Please Log In or Sign Up to access more details on this Service Provider

EncJQB7BREW98j3ix2BjbA.jpg
Openbuild network tech support. Send me a message if you have questions.


CDI install Honda xl600r Was having a hard time getting the bike started when it was warm. Coastriders diagnosed the problem as a bad cdi. Starts first kick now hot or cold. cdi is located under the tank. I ordered a new one from this website: https://www.regulatorrectifier.com/catalog/1983-1984-honda-xl600r-cdi-unit
 0     1 comment

Spindle nut install - install washer in the slot - thread spindle nut over the washer -12 ft lbs of torque to seat the bearings - 3 Thousandths play *Don't over tighten this nut. Check the spec in the manual. 1984 Chevy Van G30 Brake Maintenance
 0     0 comments

Bearing grease Bearing behind the rotor Bearing in front of rotor 1984 Chevy G30 Van 1 ton Brake maintenance
 0     0 comments

Brake pad install Thread in caliper bolts from the backside of caliper 1984 Chevy Van G30 Brake Maintenance
 0     0 comments

New Calipers Chevy G30.
 0     0 comments

Camp Shower for Roof Rack - 12 ft of 4" ABS - Reducer 4" to 3" with clean out - 45 angle - Reducer 4" to 2" - Convert 2" to 3/4 MPT female - Garden house spot 3/4 MPT male - 2 Large hose clamps - Schrader valve from on old bike tube (drill a hole in the clean out cap and push the valve through, then seal with adhesive patch compound) *** I would suggest airing this up with a bike pump. Air compressor can cause it to leak. You only need 15 psi for good flow.
 0     0 comments

Fiberglass visor. This was a junkyard find from an old boogie van.
 1     0 comments

These jump seats are from a Ford Ranger. They're great for short trips when you need space for a couple of more people. They're compact and fold up out of the way.
 0     0 comments

Used the CNC router to cut holes for my stainless steel cup holders. The table was made of plywood with a textured laminate top. Good project for testing out the CNC.
 0     0 comments

Raptor lined the interior floor of my van. 1. Removed all the seats - 1 hour 2. Sanded floor with 80 grit sandpaper to remove the rust. - 12 hours 3. Tape off the van with painters plastic and blue painters tape (3M) - 3 hours 4. Spray - 2 hours - Add 250 ml harder and 100 -50 ml tint to bottle - Mix - 60 psi set on air compressor (liner goes father and coats evenly) - For a more textured look spray at 40 psi - Spray the bottle in less than an hour http://www.raptorcoatings.com/us/en/home 8 bottles = 2 coats https://www.amazon.com/U-POL-Raptor-Urethane-Spray-Liters/dp/B01CKE8406 Pneumatic 8" orbital sander Self etching primer from Home Depot
 2     0 comments